Prepare Important Exam with 201 Exam Dumps(2024) [Q63-Q78]

Prepare Important Exam with 201 Exam Dumps(2024) 

Pass Exam Questions Efficiently With 201 Questions

NEW QUESTION # 63
A BIG-IP Administrator creates a new VLAN on BIG-IP Cluster Member A and attaches an Interface to it.
Although the Auto Config Sync is in place, the new VLAN does NOT show up on Cluster Member B. What should the BIG-IP Administrator do to ensure the new VLAN is configured on each Cluster Member?

• A. Configure a Default Route for the new VLAN on Cluster Member A.
• B. Configure the new VLAN manually on Cluster Member B.
• C. Reset the Device Trust of the BIG-IP Cluster on either Cluster Member.
• D. Enable the Interface that is attached to the new VLAN on Cluster Member A.

Answer: B

NEW QUESTION # 64
Assume a virtual server is configured with a ClientSSL profile. What would the result be if the virtual server's destination port were not 443?

• A. As long as client traffic was directed to the alternate port, the virtual server would work as intended.
• B. Since the virtual server is associated with a ClientSSL profile, it will always process traffic sent to port 443.
• C. Virtual servers with a ClientSSL profile are always configured with a destination port of 443.
• D. SSL termination could not be performed if the virtual server's port was not port 443.

Answer: A

NEW QUESTION # 65
Assume a virtual server has a ServerSSL profile. What SSL certificates are required on the BIG-IP?

• A. The BIG-IP's SSL certificates must only exist.
• B. The BIG-IP's SSL certificates must be created within the company hosting the BIG-IPs.
• C. The BIG-IP's SSL certificates must be issued from a certificate authority.
• D. No SSL certificates are required on the BIG-IP.

Answer: D

NEW QUESTION # 66
A BIG-IP Administrator is conducting maintenance on one BIG-IP appliance in an HA Pair. Why should the BIG-IP Administrator put the appliance into FORCED_OFFLINE state?

• A. To terminate existing connections to Virtual Servers and prevent the appliance from becoming active
• B. To terminate connections to the management IP and decrease persistent connections
• C. To preserve existing connections to Virtual Servers and reduce the CPU load
• D. To allow new connections to Virtual Servers and ensure the appliance becomes active

Answer: A

NEW QUESTION # 67
When initially configuring the BIG-IP system using the config utility, which two parameters can be set? (Choose two.)

• A. the IP address of the SCCP
• B. the port lockdown settings for the SCCP
• C. the port lockdown settings for the host via the management port
• D. the netmask of the host via the management port
• E. the IP address of the host via the management port
• F. the netmask of the SCCP

Answer: D,E

NEW QUESTION # 68
A site needs a virtual server that will use an iRule to parse HTTPS traffic based on HTTP header values. Which two profile types must be associated with such a virtual server? (Choose two.)

• A. TCP
• B. HTTP
• C. HTTPS
• D. ServerSSL

Answer: A,B

NEW QUESTION # 69
A BIG-IP Administrator applied the latest hotfix to an inactive boot location by mistake, and needs to downgrade back to the previous hotfix.
What should the BIG-IP Administrator do to change the boot location to the previous hotfix?

• A. Uninstall the newest hotfix and reinstall the previous hotfix
• B. Reinstall the previous hotfix and re-activate the license
• C. Reinstall the base version and install the previous hotfix
• D. Uninstall the base version and restore the UCS

Answer: C

NEW QUESTION # 70
Refer to the exhibit.

A BIG-IP Administrator needs to configure health monitors for a newly configured server pool named Pool_B.
Which health monitor settings will ensure that all pool members will be accurately marked as available or unavailable?

• A. HTTPS, HTTP, FTP, and SSH, with the Availability Requirement of at least one monitor
• B. HTTPS and HTTP with the Availability Requirement of at least one health monitor
• C. HTTPS, HTTP, FTP, and SSH with the Availability Requirement of all health monitors
• D. HTTPS, HTTP, FTP, and ICMP, with the Availability Requirement of all health monitors

Answer: A

Explanation:
From the port, the four members are HTTP, FTP, HTTPS, and SSH applications. If you want to monitor at the same time, you must configure at least one.

NEW QUESTION # 71
The ICMP monitor has been assigned to all nodes. In addition, all pools have been assigned custom monitors. The pool is marked available. If a pool is marked available (green) which situation is sufficient to cause this?

• A. All of the members of the pool have had their content updated recently and their responses no longer match the monitor.
• B. Less than 50% of the pool member nodes responded to the ICMP echo request.
• C. All of the pool member nodes are responding to the ICMP monitor as expected.
• D. Over 25% of the pool members have had their content updated and it no longer matches the receive rule of the custom monitor. The other respond as expected.

Answer: D

NEW QUESTION # 72
Assume the bigd daemon fails on the active system. Which three are possible results? (Choose three.)

• A. The active system will continue in active mode but gather member and node state information from the standby system.
• B. The active system will reboot and the standby system will go into active mode.
• C. The active system will restart the bigd daemon and continue in active mode.
• D. The active system will restart the tmm daemon and continue in active mode.
• E. The active system will failover and the standby system will go into active mode.

Answer: B,C,E

NEW QUESTION # 73
A site would like to ensure that a given web server's default page is being served correctly prior to sending it client traffic. They assigned the default HTTP monitor to the pool. What would the member status be if it sent an unexpected response to the GET request.?

• A. The pool member would be marked offline (red).
• B. The pool member would alternate between red and green.
• C. The pool member would be marked online (green).
• D. The pool member would be marked unknown (blue).

Answer: C

NEW QUESTION # 74
Refer to the exhibit.

An LTM device has a virtual server mapped to www.f5.com. Users report that when they connect to
/resources/201.1.2h.l_l.com they are unable to receive content.
What is the likely cause of the issue?

• A. The virtual address does not have ARP enabled.
• B. The virtual address does not have route advertising enabled.
• C. The pool associated with the virtual server is falling its health check.
• D. The pool associated with the virtual server does not have priority group activation enabled.

Answer: A

NEW QUESTION # 75
Refer to the exhibit.


During maintenance, the BIG-IP Administrator manually disables a pool member as shown.
What is the result?

• A. All pool members continue to process persistent connections
• B. The disabled pool member stops processing existing connections
• C. The disabled pool member stops processing persistent connections.
• D. All pool members stop accepting new connections.

Answer: A

NEW QUESTION # 76
A BIG-IP Administrator needs to determine which pool members in a pool have been manually forced offline and are NOT accepting any new traffic. Which status icon indicates this?
A)

B)

C)

D)

• A. Option
• B. Option
• C. Option
• D. Option

Answer: B

NEW QUESTION # 77
A BIG-IP Administrator needs to collect HTTP status code and HTTP method for traffic flowing through a virtual server.
Which default profile provides this information?

• A. HTTP
• B. Request Adapt
• C. Analytics
• D. Statistics

Answer: A

NEW QUESTION # 78
......

201 Questions - Truly Beneficial For Your F5 Exam: https://dumpsvce.exam4free.com/201-valid-dumps.html